- Barajar
ActivarDesactivar
- Alphabetizar
ActivarDesactivar
- Frente Primero
ActivarDesactivar
- Ambos lados
ActivarDesactivar
- Leer
ActivarDesactivar
Leyendo...
Cómo estudiar sus tarjetas
Teclas de Derecha/Izquierda: Navegar entre tarjetas.tecla derechatecla izquierda
Teclas Arriba/Abajo: Colvea la carta entre frente y dorso.tecla abajotecla arriba
Tecla H: Muestra pista (3er lado).tecla h
Tecla N: Lea el texto en voz.tecla n
Boton play
Boton play
30 Cartas en este set
- Frente
- Atrás
|
A transducer contains a chain of sensors?
(Yes -No) |
No
|
|
An advantage of using negative feedback is that it will make the system tolerant to sensor inaccuracy?
(Yes -No) |
No
|
|
Does the Arduino UNO board contain a microcontroller? (Yes - No)
|
Yes
|
|
Data Acquisition Boards always include some memory to store data?
(Yes - No) |
No
|
|
In case of a linear transfer function, zero drift has an impact on accuracy?
(Yes - No) |
Yes
|
|
If saturation is reached in a measurement system, does this imply a decrease of sensitivity?
(Yes - No) |
Yes
|
|
Measurements from digital multimeter produce the following values (4.001; 4.002; 4.001; 4.001). Which is the resolution uncertainty?
(±0.001 - ±0.0005) |
±0.0005
|
|
Is noise a source of systematic errors?
(Yes - No) |
No
|
|
A linear transfer function can be calibrated with two measurement standards?
(Yes - No) |
Yes
|
|
If the time constant of a system is 0.1 seconds does this mean that at 0.1 seconds it has reached half of the change it goes after step response?
(Yes - No) |
No
|
|
First-order sensors such as temperature sensors may briefly oscillate after a sudden change in the stimulus (temperature)?
(Yes - No) |
No
|
|
Assuming some level of noise, does it make sense to average output values from a measurement system in order to obtain a more precise measurement?<br />
(Yes - No) |
Yes
|
|
Resistors with a ±0.05% tolerance will be significantly more expensive than resistors with a ±1% tolerance? (Assume that all other features are equal)
(Yes - No) |
Yes
|
|
1.000x10^3 has four significant digits?<br />
(Yes - No) |
Yes
|
|
How many significant digits 0.1 has?
(1-2) |
1
|
|
How many significant digits 7.90 has?
(2-3) |
3
|
|
Can you be sure about the number of significant digits in 7000?
(Yes - No) |
No
|
|
How many digits you will use to report the result of 111 kg + 1 g?
(1-3) |
3
|
|
How many digits you will use to report the result of 111 kg x 1 g?
(1-3) |
1
|
|
How you will express the result of 1.2 kg - 0.02 kg?
(1.2 kg - 1.1 kg) |
1.2 kg
|
|
If L=1. 00 km with an uncertainty of 0.10 km, how you will report the value?
(1.00±0.10 km - 1.0 ± 0.1 km) |
1.00±0.10 km
|
|
Does the capacitance between two metallic plates increases as it distance decreases?
(Yes - No) |
Yes
|
|
Transformers can be employed for increasing the power of signals?
(Yes - No) |
No
|
|
Is cable shielding employed to minimize inductively coupled interferences?
(Yes - No) |
No
|
|
Resistivity (ρ) units?
(Ω.m - Ω/m) |
Ω.m
|
|
Electronic noise in a sensor can be minimized by amplifying its output signal?
(Yes - No) |
No
|
|
If an AC current is applied through the body, which frequency is more likely to cause fibrillation?
(10 Hz - 100 kHz) |
10 Hz
|
|
Are DC voltages safer than AC voltages?
(Yes - No) |
Yes
|
|
Are battery powered devices free from electrical hazards?
(Yes - No) |
No
|
|
Are Residual-Current Devices (RCDs) employed to prevent currents through the human body to earth?
(Yes - No) |
Yes
|
